Project · Sanford, FL · 2025-10-28
Grab Bar Installation in Sanford, FL
Two grab bars the homeowner picked out, mounted on marble-look tile in a Sanford walk-in shower.
What the customer needed
This Sanford homeowner already had their two grab bars and wanted them installed properly. The job was in October 2025, in a walk-in shower with large marble-look tiles, a pebble-stone floor and a glass panel. We work across Sanford, from the older streets near Lake Monroe to the newer neighborhoods, and bringing your own bars is always welcome.
The finished install
1. Finished. The vertical bar by the curb and the horizontal bar on the back wall.
What we did
We mounted one bar vertically on the side wall just past the shower curb, a natural handhold for stepping in over the curb. The other runs horizontally along the back wall, partly behind the glass panel, for steadying yourself while you shower. The homeowner supplied both bars; we handled the layout, the drilling through the tile and the mounting, to our install standard below.
Our install standard
- Every bar secured into studs or blocking, or with fasteners rated for grab bar loads, so the installation holds 250 lb
- ADA guideline height (33 to 36 inches to the top of the bar) unless the customer’s needs differ
- Every hole sealed and every bar pull-tested before we leave
- Photos of the completed work, as proof for the customer and the warranty